D-c-fix Oxide Steel Self-adhesive Vinyl Wrap Film - 67 5 X 1 5 M

D-C-Fix Oxide Steel Self-Adhesive Vinyl Wrap Film - 67.5 x 1.5 m Designed by D-C-Fix, this self-adhesive vinyl wrap roll allows you to showcase the industrial appearance of oxidised steel without the cost, inconvenience and effort of installing and looking after the real thing. Highly-rated for opacity, lightfastedness and durability, it's designed with convenience in mind, and allows you to produce a whole new look in a fraction of the time it would normally take. Applying it is incredibly easy, as you just need to peel off the backing little by little, stick it on your chosen surface, then smooth it down to eliminate air bubbles and smaller imperfections. A water-based, low-tack adhesion means you can rest assured in the knowledge that it can be peeled back and repositioned if you don't quite line it up right first time. It's naturally pliable and easy to wrap around corners or worktop edges, however you can also gently warm it with a hairdryer to make things even simpler. A total coverage area of 67.5 cm x 1.5 m means it's ideal for refreshing a bedside table or smaller piece of decor. Heat-resistant up to 70 degrees Celsius, it will withstand the heat from hot cups and plates (but not pans) when used on kitchen counters, and you can also add sealant along the edges to make it watertight. Not only does this mean you can apply it in the kitchen, above a sink or near your hob, but also around your bath. This vinyl is fully removable, too, so if you damage or stain a section, or simply fancy changing the look, you can use a hairdryer to heat it up before peeling it off. Please note: as this vinyl is not heat-resistant beyond 70 degrees C, it should not be used as a splashback behind your hob. Depth: 5.5 CM Height: 5.5 CM Material Content: PVC Width: 67.5 CM Care Kit: N Self adhesive Repositonable during application, peel back and reapply Heat resistant to 70C Easy application Wipe clean, use household cleaning products, no abrasives, just a soft cloth Use a hairdryer for curved edges, to make the vinyl more pliable Use a light spray of water on smooth surfaces like glass Water based adhesive Removable